Products>MCU for Consumer LCD Products>ST20P18
ST20P18
8-bit Single Chip Microcontroller with 16K bytes PROM(OTP)

Product Description

ST20P18 is a low-cost, high-performance, fully static, 8-bit microcontroller designed with CMOS silicon gate technology. It comes with 8-bit pipeline CPU core, SRAM, timer, LCD driver, I/O port, PSG, RFC, CGR, OTP program ROM and built-in dual oscillator. And also, some new functions have been added in the ST20P18 to enhance the performance of ST2016 for more system application.

Features
  • 8-Bit Static Pipeline CPU
  • ROM: 16K x 8 bits PROM(OTP)
  • RAM: 192 x 8 bits
  • 32-Level Deep Stack
  • Operating Voltage : 2.4V ~ 5.5V
  • - OTP option bit to enable
  • General-Purpose I/O (GPIO) Ports
    - Up to 28 pins are programmable CMOS I/O, 20 pins share with LCD SEGMENTs
    - 8 open drain output pins share with LCD COMs
    - Hardware de-bounce option for Port-A
    - Bit programmable pull-up for input pins
  • 2 Input Pins
    - OTP option bit to select (shared with OSCX)
  • Timer / Counter
    - One 8-bit timer / 16-bit event counter
    - One 8-bit BASE timer
  • Five Powerful Interrupt Sources
    - External interrupt (edge trigger) / RFC interrupt(Share with external interrupt)
    - TIMER1 interrupt
    - BASE timer interrupt
    - PORTA[7~0] interrupt (transition trigger)
    - DAC reload interrupt
  • Watchdog Timer (WDT)
    - With its own low power internal oscillator for reliability
    - Four selectable time bases
    - WDT reset CPU only
    - OTP option bit to enable
    - One option bit is selectable to reset or not in WAI1 and STP mode
  • Dual Clock Source with Warm-up Timer
    - OSCX: Low frequency crystal oscillator with 32768Hz
    - OSC: High frequency RC oscillator from 500K ~ 8MHz
  • On-chip Internal Oscillator for WDT
    - < 5uA typical @ 3V, 27¢J
  • LCD Controller Driver
    - 16 level contrast control
    - 320 ( 8x40) dots ( 1/8 duty, 1/4 bias, programmable)
    - 160 ( 4x40) dots ( 1/4 duty, 1/3 bias, programmable)
    - Two clock source options: RC and resonator oscillator
    - Keyboard scan function supported on 40 shared segment drives
    - Internal bias resistors(1/4 bias & 1/3 bias) with 32 level driving strength control
  • Programmable Sound Generator (PSG)
    - Tone generator
    - Sound effect generator
    - 16 level volume control
    - Digital DAC for speech / tone
  • Resistor Frequency Converter (RFC)
    - Up to 4 resistors measurement
    - Built-in one independent 16-bits counter without sharing with timer counter
    - 3 clock sources for RFC counter: SYSCK, OSCX and INTX
    - 5 scales of clock divider for RFC counter
  • Carrier Wave Generator(CGR)
    - Built-in one digital PLL
    - Standard clock rate output for remote control
  • Three Power Down Modes
    - WAI0 mode
    - WAI1 mode
    - STP mode

Downloads

No documents found

File Size Version Creation Date